Filter
Top Products
12. BI-WIRING OPTION
Bi-wiring requires two sets of speaker cables. They may be identical or one set may be
specialized for high frequencies and the other specialized for low frequencies.
A. Remove both jumpers on the crossover box.
B. Connect one set of cables to the low cable input and the other set to the high
cable input. Connect the other end of the cables together (observe +/- polarity),
and connect to one channel of the amplifier outputs. If frequency specialized
cables are used, connect them to their respective inputs. In either case, the
other ends are connected to the same amplifier channel.
C. Repeat same procedure for the other channel.
13. MAINTENANCE
The wood trim can be cleaned and polished with a damp cloth. In the event the speaker's
fabric is damaged or soiled, replacement covers are available. For owners with cats, we
recommend cat repellant around the base of the speakers. Do not use a vacuum cleaner!
14. SERVICE
In the unlikely event you should need service for your MG3.6/R loudspeakers, we
recommend you return them to your dealer. He is experienced in providing service and
can assist you if the speakers must be returned to the factory.
If it is determined that your speakers must be returned for repair, you must call the
factory first for a return authorization repair number. Ship your speakers (freight
prepaid-ask for Class 100) to:
Magnepan, Incorporated
1645 Ninth St.
White Bear Lake, MN 55110
651-426-1645 or 800-474-1646
Include a packing slip or letter describing the nature of the problem and your return
authorization repair number. Please include your name, address, and a daytime
telephone number.
Before packaging, very carefully install the steel protector strips over the ribbons. Do
not let the steel strips slap against the magnets.
THE RIBBON ELEMENT WILL BE RUPTURED IF SHIPPED WITHOUT THE STEEL
PROTECTOR STRIPS AND WOULD NOT BE COVERED UNDER THE WARRANTY.