Filter
Top Products
21
English
TAPE
Auto Reverse Playback
(only on
tape deck 2)
• Press A. REV to select the different
playback modes.
åå
åå
å ....... to record or playback on one
side of the tape. The tape stops
at the end of one side.
çç
çç
ç ...... to record or playback on both
sides of the tape. The tape then
stops.
∫∫
∫∫
∫ .... to playback continuously on
both sides of the tape up to a
maximum of 10 times per side
unless you press STOP.
Rewind/Fast Forward
When playback is stopped
1 You can rewind or fast forward the tape
by pressing S or
T
(or
à
/
á
on the remote control)
respectively.
™ "TA 1 XXX" or "TA 2 XXX"
will be displayed depending on which
button is pressed.
™ The tape will stop automatically at
the end of the rewinding or fast
forwarding.
2 Press STOP to stop rewinding or fast
forwarding.
Tape Playback
1 Press TAPE to select TAPE mode.
™ “TAPE 1” or “TAPE 2” will be
displayed.
• Press TAPE again to select either tape
deck 1 or tape deck 2.
2 Load the tape into the desired tape
deck.
3 Press PLAYÉ to start playback.
3a(For Tape Deck 2 only)
Press A•B (SIDE) to switch playback
between side A and B.
™ The
BACK or FRONT flag appears on the
display, depending on the side
selected.
3b(For Tape Deck 2 only)
Press A. REV to select the different type
of playback mode
(see auto reverse
playback)
.
4 Press STOP to end playback.
Note:
– To change side before playback begins,
use the SIDE button on the remote
control.
During playback
• Press and hold S or
T
(or
à
/
á
on the remote control)
until the
desired passage is located.
™ During searching, the sound is
reduced to a low volume.
™ When you release S or
T ,
the tape continues playing.
Notes:
–"
XXX
" denotes the tape counter
number. It will automatically set to zero
after detecting end of tape or changing
tape play direction on TAPE 2. To reset
the tape counter number to zero during
playback, press the DIM button for more
than 2 seconds.
– During rewinding or fast forwarding of a
tape, it is also possible to select another
source (e.g. 3 CDC, TUNER or CDR/
AUX).
– Before use, check and tighten slack tape
with a pencil. Slack tape may get
jammed or may burst in the mechanism.
– C-120 tape is extremely thin and is
easily deformed or damaged. It is not
recommended for use in this system.
– Store the tapes at room temperature
and do not put them too close to a
magnetic field (for example, a
transformer, TV, or speaker).
.