Magnadyne M9999 Stereo Receiver User Manual


 
Listening to the Radio
1. Push the “LEVEL” knob (2) once to turn the unit on.
(Figure A)
2. Press the “BAND” button (12) to select a radio
band: FM1, FM2, FM3, AM1 or AM2.
3. To manually tune in a radio station, rotate the
“Tuning” knob (3) right or left until the desired
station is located.
4. To “Automatic Scan” to the next strong station.
Press and release the “Tuning” knob (3). The
tuner will scan up and wait for 5 seconds then
scan up again. Once the desired station is found,
press the knob again to stop the scan function.
5.
To “Seek” up or down to the next station, momen-
tarily rotate the “Tuning” knob (3) right or left and
hold it for more than one second then release it.
Programming the Unit
You can program up to 15 FM radio stations and 10
AM radio stations.
1. Select FM1, FM2, FM3, AM1 or AM2 by pressing
the “BAND” button (12) repeatedly while watch-
ing the indication on the display (16) (Figure C).
2. Use the “Tuning” or “Scan” (3) knob to select the
desired station.
3. Press and hold one of the five station recall but-
tons (4-8). The button number and “CH” appears
in the display area (16). Release the button.
4. Repeat the procedure to memorize more stations
as desired.
Sound Controls
Volume Button:
Press the “SEL” button (1) to select between the
sound controls: Volume, Bass, Treble, Balance
and Fader. The sound control will be displayed in
the display area (Figure B).
Use the Level Knob (2) to make these adjustments:
Bass Control:
The bass control adjusts the amount of low
frequency that you hear.
Treble Control:
The treble control adjusts the amount of high
frequency that you hear.
Balance Control:
The balance control adjusts the amount of sound
output to the left and right speakers.
Fader Control:
The fader control adjusts the amount of sound
output to the front and rear speakers.
Figure A
Figure B
Figure C
4