Filter
Top Products
8
Installation
Space Requirements:
To mount your new Magnadyne unit, you will need a rectangle hole
in the mounting location 183mm (width) x 53mm (height), (7
1
⁄8” x
2
1
⁄8”) and a full 7” of unobstructed space behind the mounting
location.
Step 1:
After obtaining the required space and mounting hold dimensions
required, release the mounting sleeve from the unit by pressing
inward on the sides of the unit and sliding the mounting sleeve off
the unit.
Insert the mounting sleeve into the hole on the dashboard. Secure
it by bending the tabs inward as shown in fig 1. Select the
appropriate tab according to the thickness of the dashboard.
Step 2:
Bring the power, ground, antenna and speaker wires through the
center of the mounting sleeve. Make all the speaker and power
connections to the main harness supplied with the unit. Refer to the
“wiring” section of this unit for proper connection. After all the
connections have been made and are correct, plug the harness and
the antenna cable into the mating plugs located on the rear of the
unit.
Step 3:
Turn on the ignition key and do a pre-installation check of all the
functions with the unit out of the dashboard to make sure that
everything is operating properly before final installation.
Step 4:
Securely attach the rear support strap provided to the rear of the
unit with the fasteners provided. Bend the strap to allow the unit to
slide into it’s mounting sleeve. Reach up behind the unit and grab
the strap while sliding the unit into the mounting sleeve until it
snaps into place. Secure the end of the strap to a solid portion of
the dashboard structure or the fire wall.
Removing the Unit:
In the event that the unit requires removal from it’s mounting
location, repeat the following procedures.
Step 1: Release the rear support strap.
Step 2: Remove the end caps.
Step 3: Insert the keys on the left and right side.
Step 4: Slide the key up at an angle.
Step 5: Slowly pull the key out approximately 3/8” of an inch. This
presses the two stopers down and releases the unit.
Step 6: Slide the unit from the metal housing.
Step 7: Disconnect the wire harness and the antenna.
M2080 English 08/04/00 7:52 AM Page 8