Magnadyne EAX540 CD Player User Manual


 
7
Position of the built-in anti-vibration board
This unit can be installed horizontally (suspended), vertically, and at a 45° angle.
Once the installation position has been decided, it’s necessary to set the position of
the built-in anti-vibration board inside the unit. Please do this before performing the
procedure listed below. Vibration may cause the disc to skip if the unit is used before
properly setting the anti-vibration board.
At the time of shipping, the built-in anti-vibration board is set for horizontal installation
“0”.
There are built-in anti-vibration boards on both the left and right sides.
Set the anti-vibration board position with a screwdriver before attaching the brackets.
For use when unit is installed horizontally or suspended:
Confirm that the built-in anti-vibration board is set to position “0”.
For use when unit is installed vertically:
The built-in anti-vibration board should be set to position “90”.
For use when unit is installed at a 45° angle:
The built-in anti-vibration board should be set to position “45°”.
45
0
90
45
0
90
45°
45
0
90