Filter
Top Products
2
CONTENTS
HINTS FOR CORRECT AND SAFE OPERATION 2
HOW TO USE THE MAGAZINE 3
PRECAUTIONS FOR HANDLING DISCS 4
INSTALLATION PARTS 5
WIRING 5
RESET FUNCTION 5
BEFORE INSTALLING THE UNIT 6
• Transport Lock Screws 6
• Installation and Wiring Precautions 6
• Position of the built-in anti-vibration Board 7
INSTALLATION 8
• Procedure for Installation on Carpet (Horizontal Position) 8
• Procedure for Installation on Carpet (Vertical Position) 9
• Procedure for Installation on Carpet (At a 45° angle) 10
• Procedure for Installation (Suspended Position) 11
HANDLING THE DISCS 12
TROUBLE SHOOTING 12
HINTS FOR CORRECT AND SAFE OPERATION
This CD Changer is designed to be operated only on +12 volt DC negative ground
systems. The unit cannot be used on +24 volt or positive ground systems.
The unit may not operate correctly in extremely hot or cold temperatures. The unit is
equipped with a built in self-protection circuit. When the temperature reaches a preset
level, the protection circuit halts all unit operations. If this should happen, open a
window and allow the car to cool.
Condensation
Moisture can condense on the laser lens of the CD changer during rainy and humid
days, or right after the heater is turned on in the car. If this should happen the unit
will not operate correctly. To remedy the situation, remove the magazine from the unit
and wait approximately one hour. During this time the moisture will evaporate and the
unit will operate normally.
Remove the magazine from the unit when it is not being used during hot weather and
the CD changer is not used for long periods of time.