Filter
Top Products
The Audioaccess PX-600 keypads, front panel and
IR remote controls are designed for simple, intuitive
system operation. You will not need lengthy training
or a full understanding of audio/video systems to
master the operation of your PX-600 system. Use
the following outline (which focuses on the opera-
tion from the keypad) and experiment. Check with
your dealer to find out about any special or alternate
features that may have been installed for you. You’ll
soon be an expert!
ON
(Substitute the word POWER for PX-600
front panel operation)
▲ To turn on a single zone, momentarily press
the ON button. The ON LED will illuminate on
keypads. The FM (TUNER on front panel) will
be selected when a zone is first turned on.
▲ To turn off a single zone, momentarily press
the ON button again.
▲ To turn on a group of zones (this is called an
ALL ON group), start with the zone off, then
press-and-hold the ON button for about two
seconds or until the ON LED flashes.
▲ To turn off an ALL ON group, momentarily
press the ON button from any zone within the
group.
1
▲ To turn off all zones in the system, as well
as the power to the source components,
regardless of ALL ON grouping, go to any
keypad, make sure it is ON, then press-and-
hold the ON button for about two seconds
or until the ON LED flashes on a keypad. All
zones will turn off. (The front panel has a
separate ALL OFF button.)
1
Certain options are available that affect the opera-
tion of ALL ON. For example, if your system is
programmed with the TIMEOUT feature, the zones in
an ALL ON group may be set up to revert back to
independent operation 30 seconds after the ALL ON
is initiated. If this is the case, momentarily pressing
the ON button will only turn off the zone you’re in.
Check with your dealer for further information.
VOLUME ▲ ▼
▲ To increase the volume, press ▲.To
decrease the volume press ▼. (On the
front panel use the large knob.)
▲ To mute the audio, press ▲ and ▼ together.
(Press the MUTE button on the front panel
or IR remote control to get the same
response.)
▲ To un-mute the audio, press either the ▲
or ▼ buttons. (Press MUTE again on the
front panel.)
Source Equipment Control and
Interface Section
Inputs:
▲ Trigger input to facilitate sharing source
equipment (controls switched outlet and
"stop" commands)
▲ Keypad interface connector
▲ DC voltage input for zone trigger outputs
▲ Hardwired IR input to control main zone
from industry standard IR receivers
Outputs:
▲ Trigger output from each zone to control
external relays
▲ One system trigger output to control exter-
nal relay (active when system is on)
▲ Six infrared emitter jacks, one for each
audio source (5) plus ALL
▲ IR loopthru output
▲ Switched outlet (North American model
only)
Audio Section
Inputs:
▲ Five stereo source inputs, 1 mono page input,
each with loopthru capability
▲ Input impedance: 10k Ω
▲ Maximum input voltage: 3.5 Vrms
Outputs:
▲ Six stereo preamp outputs with independent
volume, bass and treble
▲ Six stereo zone outputs (fixed level, post input
selector)
▲ Tape output from the main zone (zone 6)
OPERATION
SYSTEM
SPECIFICATIONS
3 8