Active Speaker System
SRM350
SPEAKER
SRM350
oF 6 PAGES
2
O F 6 P A G E S
Active Speaker System
SRM350
oF 6 PAGES
3
O F 6 P A G E S
Active Speaker System
SRM350
oF 6 PAGES
4
O F 6 P A G E S
Low Frequency Section
Number of Drivers 1
Woofer Diameter 10 in/250 mm
Voice Coil Diameter 2.0 in/51 mm
Power Handling
250 watts rms (long term)
1
Sensitivity 96 dB (1W@1m)
Frequency Range 61 Hz to 3000 Hz
Magnet Type Ferrite
Construction Features
Basic Design Asymmetrical Trapezoidal
Material Polypropylene
Finish Grey, textured nish
Handles One on side, one on top
Grille Perforated metal with weather-
resistant coating
Line Input Power
Power Consumption
120W with musical program
and Limit LED blinking
US 120 VAC, 60Hz
Recommended amperage service 2.5 amps
Europe 230 VAC, 50Hz
Recommended amperage service 1.25 amps
Japan 100 VAC, 50/60Hz
Recommended amperage service 3.0 amps
AC connector 3-pin IEC 250 VAC
Control System Function
Electronic Crossover
Phase Alignment
Equalization
Parametric equalization
Safety Features
Protection Low Frequency Dynamic Bass
Protection, Power Supply and
Amplier Thermal Protection
Display LEDs Signal Present, Limit, Power ON
Physical
Height 20.75 in/527 mm
Width 13.10 in/333 mm
Depth 12.25 in/311 mm
Weight 32.0 lb/14.5 kg
Options
Accessory plate for top and bottom of enclosure for rigging
SRM350 Specications
System Acoustic
Frequency Response (–3 dB) 83 Hz -18.5 kHz
Frequency Range (–10 dB) 61 Hz-22 kHz
Max SPL Long-term 118 dB
Max SPL Peak 121 dB
Crossover Linkwitz-Riley, 24 dB/octave @ 2400 Hz
Audio
Input Bal./unbal. female combination XLR/TRS
Loop-through (parallel w/input) Bal./unbal. Male XLR
Input Protection RFI and level protected
Level Control Rotating knob (off to +45 dB)
Sensitivity (center detent) Line: +4 dBu
Mic: –36 dBu
Maximum Input Level +22 dBu
Acoustic Contour Equalization (peaking) +3 dB @ 100 Hz
+3 dB @ 12 kHz
Accessory Interface ±15 VDC, normalized signal I/O
Operating Temperature Range –10°C to 45°C
(14°F to 113°F)
Ampliers
Total Amplier Power 195 watts continuous*
High Frequency 30 watts*
Type Class H
Rated THD .03%
Low Frequency 165 watts*
Type Class H
Rated THD 0.03%
*Rated power is continuous rms wattage into transducer’s rated impedance @ 1 kHz for
the HF amplier and @ 100 Hz for the LF amplier
High Frequency Section
Diaphragm Size 1.4 in/36 mm
Horn Exit Diameter 1.0 in/25 mm
Power Handling
75 watts rms (long term)
1
Sensitivity 104 dB (1W@1m)
Frequency Range 1000 Hz to 20 kHz
Nominal Impedance 16 ohms
Diaphragm Material Titanium
Magnet Type Ferrite
Horn Design
Horizontal Coverage 90° 1 kHz to 20 kHz avg.
Vertical Coverage
80° 1 kHz to 20 kHz avg.
Type Exponential and conical
Mouth Size 11.1 in x 6.1 in/
283 mm x 154 mm
Throat size 1.0 in/25 mm
1
Measured on-axis in the far eld, referenced back to 1 watt rms from maxi-
mum power and to 1 meter distance using the inverse square law.