Filter
Top Products
9
SM
SLAVE/MASTER
SLAVE
IN
INPUT/OUTPUT
MASTER
OUT
LEFT
IN
OUT
RIGHT
IN OUT
FOOTSWITCH
*MAX OPEN CIRCUIT 24V
*MAX CLOSED CIRCUIT 1A
OPEN - SUB ON, L/R BASS MANAGED
CLOSED - SUB DEFEAT, L/R FULL RANGE
REMOTE INDICATOR
SUBSONIC FILTER
FLAT
15Hz
OFF NORMAL
POLARITY
INPUT SENSITIVITY
0°
180°
FILTER SELECT
LFE GAIN
CROSSOVER
CROSSOVER
VARIABLE
110Hz ELIPTICAL
0dB
+
10dB
FILTER BYPASS
FILTER IN
FULL RANGE
110Hz55Hz
80Hz
SUB SAT
110Hz55Hz
80Hz
SUB SAT
(MONO)
POWER SUB BYPASSED
OUTIN
L
R
L
R
*TO INSURE PRODUCT SAFETY, POWER SUPPLIES MEETING CLASS-2 INSULATION
REQUIREMENTS SHOULD ONLY BE USED WITH THIS CONNECTOR
SUBWOOFER BYPASS
REMOTE INDICATOR CIRCUIT CLOSED WHEN SUB BYPASSED
POLARITY &
INPUT SENSITIVITY ACTIVE
PROCESSED
SIGNAL
POLARITY
POLARIT
Y
0°
180°
THX = 0˚
This switch reverses the polarity of the sig-
nal going to the subwoofer amplifier by 180º.
It has no effect on the signal at the
LEFT
and
RIGHT OUT
or the
MASTER OUT
.
There is no right or wrong setting for this
switch. Listen to the overall blend of the
subwoofer with the rest of the system, and select
the switch position that gives you the best sound.
LEFT AND RIGHT INPUTS
Balanced XLR female and unbalanced RCA
female connectors are provided for the left and
right inputs. Connect the full-range line-level
signal from the mixer or preamplifier to one of
these input jacks.
The connectors are wired as follows (per
the AES/IEC standard):
XLR RCA
Hot (+) Pin 2 Tip
Cold (–) Pin 3 —
Shield (Ground) Pin 1 Shield
If connecting a single subwoofer or LFE out-
put to the HRS150, use the
LEFT (MONO)
input with the
FILTER BYPASS
switch pushed in.
LEFT AND RIGHT OUTPUTS
Balanced XLR male and unbalanced RCA fe-
male connectors are provided for the line-level
left and right high-pass outputs. Connect these
to the inputs of the main speakers (if they are
powered speakers) or to the inputs of the am-
plifier powering the main speakers.
The signal at the left and right outputs is
post-crossover. The low-pass output from the
crossover goes to the internal power amplifier
in the HRS150, while the high-pass output goes
to these output jacks.
CROSSOVER
CROSSOVER
SUB
110Hz55Hz
80Hz
SAT
THX = 80 Hz
This adjusts the crossover frequency for the
built-in 24 dB/octave Linkwitz-Riley variable
crossover. The crossover frequency can be ad-
justed from 55 Hz to 110 Hz.
POLARITY
(N/A)
LFE GAIN
SUBSONIC FILTER
CROSSOVER CONTROLS
FILTER SELECT
FILTER BYPASS
NORMAL
80Hz
SUB SAT
INPUT SENSITIVITY
THX PM3 SETTINGS