CE Declaration of Conformity
Linn Products Ltd declare that this product is in conformance with the LowVoltage
Directive 73/23/EEC and Electromagnetic Compatibility 89/336/EEC as amended by
92/31/EEC and 93/68/EEC.The conformity of the designated product with the
provisions of Directivenumber 73/23/EEC (LVD) is proved by full compliance with
the followingstandards:
Standard number Date of issue Test type
EN60065 1998 General requirements
Marking
Hazardous radiation
Heating under normal conditions
Shock hazards under normal
operating conditions
Insulation requirements
Fault conditions
Mechanical strength
Parts connected to the mains supply
Components
Terminal devices
External flexible cords
Electrical connections and
mechanical fixings
Protection against electric shock
Stability and mechanical hazards
Resistance to fire
The conformity of the designated product with the provisions of Directive
number 89/336/EEC (EMC) is proved by full compliance with the following
standards:
Standard number Date of issue Test type
EN55013 2001 Conducted emissions
EN55013 2001 Absorbed emissions
EN55020 2002 Immunity
FCC notice
NOTE: This equipment has been tested and found to comply with thelimits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed
to provide reasonable protection against harmfulinterference in a residential
installation. This equipment generates, usesand can radiate radio frequency energy
and, if not installed and used inaccordance with the instructions, may cause harmful
interference to radiocommunications. However, there is no guarantee that
interference will notoccur in a particular installation.If this equipment does cause
harmful interference to radio or televisionreception, which can be determined by
turning the equipment off and on,the user is encouraged to try to correct the
interference by one or more ofthe following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
iv