Filter
Top Products
ii
GENERAL SAFETY INSTRUCTIONS
1. Read instructions. Read the safety and operating instructions before
operating the appliance.
2. Retain the instructions. Retain the safety and operating instructions for
future reference.
3. Heed warnings. Observe all warnings on the appliance and in the operating
instructions.
4. Follow instructions. Follow all operating and use instructions.
5. Water and moisture. Do not use the appliance near water, for example near
a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near
a swimming pool and the like.
6. Carts and stands. Use only with a cart or stand that is recommended by the
manufacturer.
6a. An appliance and cart combination should be used with care. Quick stops,
excessive force, and uneven surfaces may cause the appliance and cart to
overturn.
7. Wall or ceiling mounting. Mount to a wall or ceiling only as recommended
by the manufacturer.
8. Ventilation. Site the appliance so that its location or position does not
interfere with its proper ventilation. For example, the appliance should not
be situated on a bed, sofa, rug, or similar surface that may block the
ventilation openings, or placed in a built-in installation such as a bookcase
or cabinet that may impede the flow of air through the ventilation
openings.
9. Heat. Site the appliance away from heat sources such as radiators, heaters,
stoves, or other appliances (including amplifiers) that produce heat.
10. Power sources. Connect the appliance to a power supply only of the type
described in the operating instructions or marked on the appliance.
11. Grounding or polarization. Do not defeat the precautions taken to ground
or polarize the supply to the appliance.
12. Power cord protection. Route power cords so that they are not likely to be
walked on or pinched by items placed upon or against them, paying
particular attention to cords at plugs, power sockets, and at the point
where they exit from the appliance.
13. Protective attachment plug. As a safety feature the product is equipped
with an attachment plug containing overload protection. Should the plug
need replacing ensure that a replacement is used which has the same
overload protection as the original.
14. Cleaning. The product should be cleaned only as recommended by the
manufacturer.
15. Power lines. An outdoor antenna should be located away from power lines.
16. Outdoor antenna grounding. If an outdoor antenna is connected to the
tuner/receiver ensure that the antenna system is grounded to provide
some protection against voltage surges and static build up.
In the USA see article 810 of the National Electrical Code ANSI/NFPA 70
concerning installation requirements.