Filter
Top Products
5
Dimmer/Switch Operating Instructions
MULTISET PRO® DIMMER
• To Turn light on to preset level, tap top of rocker, the dimmer fades up at the 1.5 second rate.
• A second tap of the rocker fades the dimmer to full brightness.
• To adjust the light level, press and hold top or bottom of rocker until desired light level is reached, and then release.
• To turn lights off, tap the bottom of the rocker. The dimmer fades at the 3 second fade rate.
• To quickly return to the preset level when light is on, quickly tap OFF and then ON. The lights adjust to the preset level.
• To bypass the fade rate and turn the lights to full ON or OFF, double tap the dimmer for ON or OFF.
• If the Master is in the OFF scene, the Master ON button illuminates when any dimmer is turned on.
• To change the preset level of the current scene:
• Press and hold the rocker until lights reach the desired level then release.
• Press the small set button next to the switch to save the preset in memory.
LEDs on the MultiSet Pro® Dimmer/Switch indicate status:
1. Red LED is on when Dimmer/Switch is off to locate Dimmer/Switch when room is dark.
2. As many as 3 green LEDs may be illuminated at any given time. The bright green LED
indicates the current level of the dimmer. The medium green LED indicates the preset level
of the current scene. The dim green LED indicates the preset level of the ON scene.
MULTISET PRO® UNIVERSAL ELECTRONIC SWITCH (NON-DIM)
The MultiSet Pro® Universal Electronic Switch can be programmed as a four or five-scene non-
dim switch. When programmed as a five-scene device, it is not suitable for 3-way applications.
The default mode of the switch is as a normal (4-scene) non-dim device. The AV (5-scene) mode allows the non-dim switch to remain
off when the master ON button is pressed.
To change the mode of the switch:
1. Tap OFF on the Master to place the switch in the OFF scene.
2. Press and hold the SET button. After 3 Seconds, a green LED illuminates on the bargraph. If the switch is currently in normal
mode, the bottom green LED illuminates. If it is in AV mode, the top LED illuminates.
3. Tap the top of the rocker once to toggle the mode.
4. Release the SET button.
Note: In normal mode, a “soft start” feature is utilized to extend bulb life. In AV mode, the “soft start” feature is not
implemented.
Red LED
Green LED
Set
Button
After you have completed installation of all the MultiSet Pro® devices and have
energized the system, each scene can be programmed.
1. Tap the preset button (ON, A - L) on the MultiSet Pro® Master that you wish to
program (see Step 1, Figure 8).
2. Adjust each MultiSet Pro® Dimmer to the desired intensity and the MultiSet Pro®
Switches to either ON or OFF (see above).
3. Press the Set button on each device (see Step 3, pg. 7) after all devices have been
adjusted.
Repeat Steps 1-3 until all scenes have been programmed.
Programming Scenes
F E
H
J
L K
I
G
Step 1
Preset
Buttons
(ON, A, B
C, D)
Preset
Buttons
(E-L)
Figure 7
Figure 8
MULTISET PRO
®
- PRE-WIRED DIMMING CABINET MDC20
Installation
and Operation