Filter
Top Products
12
Specifications
Specifications subject to change without notice
Troubleshooting
Symptom Diagnosis Remedy
Amplifier does not
turn on.
Amplifier Noise
(Turn-On Pop)
Engine Noise
B+ or REM not between 10.5 and
15.5 volts or no voltage present
Amplifier is not properly grounded.
Voltage spike from source unit is
entering amplifier’s input
Noise is radiating into signal cables
Check the alternator, battery, fuse,
and wiring and repair as necessary
Check wiring and repair as necessary
Connect a relay turn-on module to
REM terminal if pops are eliminated
with no input signal to amplifier
Re-route signal cables away from
sources of high current
MODEL- Storm X1.1000.1D X1.2000.1D X1.400.2 X1.800.4
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4Ω Load Per Channel 400 Watts x 1 700 Watts x 1 100 Watts x 2 100 Watts x 4
2Ω Load Per Channel 700 Watts x 1 1200 Watts x 1 200 Watts x 2 200 Watts x 4
4Ω Load Bridged (Mono) 400 Watts x 1 400 Watts x 2
X1.1000.1D & X1.2000.1D Only
1Ω Load Bridged 1000 Watts x 1 2000 Watts x 1
Dimensions: -
add 1.5" (xcm) to length for mounting feet
Height 2.2" (5.6cm) 2.2" (5.6cm) 2.2" (5.6cm) 2.2" (5.6cm)
Width 10.4" (26.42cm) 10.4" (26.42cm) 10.4" (26.42cm) 10.4" (26.42cm)
Length 14" (35.56cm) 22.0" (56.00cm) 15.2" (30.61cm) 18.6" (47.24cm)
Signal-to-Noise Ratio >90dB A-weighted
Input Sensitivity 150mV - 4V
Crossover (X1.1000.1D & X1.2000.1D only) 24dB/octave Low Pass only
Crossover (X1.400.2 & X1.800.4 only) 24dB/octave HPF/Flat/LPF Switch
Crossover Frequency variable from 50Hz to 250Hz
Channel Separation 50dB
Bass Equalization (X1.1000.1D & X1.2000.1D only) Variable from 0dB to +12dB @ 20-80Hz