Filter
Top Products
33
Operation
Presetting the
XM Satellite Radio
Stations
You can preset 50 stations for XM. Before tuning,
make sure that you have turned down the volume.
1. Press Band to select XM band.
2. Use XM CH - or XM CH + on the Remote Control
to select the desired channel.
3. Press PROG/MEMO. on the Remote Control.
4. Press PRESET v or V on the Remote Control to
select the preset number you want.
5. Press PROG/MEMO. on the Remote Control
again.
The station is stored.
6. Repeat steps 2 to 5 to store other stations.
To clear all the stored stations
Press and hold PROG/MEMO. for about two seconds
and “ERASE ALL” is shown in the display window and
then press PROG/MEMO. again, the stations are
cleared.
If you have accidentally entered into the "ERASE
XM" mode and you do not wish to clear the
memory, do not press any key. After a few seconds,
the "ERASE XM" display will go off by itself and
change to normal mode.
Channel Selection
Preset Search
Use 3/4 on the Remote Control repeatedly to select
the preset station you want.
Direct Tuning
1. Using Numeric button on Remote Control, select
channel number directly.
2. Press ENTER after more than one numeric key
input, system moves to new channel immediately.
Channel up/down
Use XM CH - or XM CH + repeatedly to select the
channel you want.
Category Search
1. Select the Category Search mode using the CAT
key on the Remote Control.
(CAT Icon Blinking in Category Search mode.)
2. 3/4 changes target of category for search, XM CH
- or XM CH + selects next channel of selected
category in category search mode
Note:
Category type of current channel displays for 3
seconds when category key is inputted in not category
display mode
Category search mode is released below case.
• CAT is inputted in Category search mode.
• No input of 3/4, XM CH - or XM CH + key for 15
seconds.
Advisory Message
XM Passport System is not
connected
• Check the connection of XM
Passport System
XM Passport System does not
work properly
• Need service of XM Passport
System
XM Passport System is not
activated, or User does not have
authorization for specific channel
• Subscribe activation of XM
Passport System
Receiving signal is too weak
• XM Passport System to south
window for best reception
Selected channel is not
broadcasting currently.
• Check programming list, select
another channel.
XM Passport System is now
decoding channel.
• Wait completion of decoding
process
Selected channel is not available.
• Check programming list, select
another channel.
Channel label or Song name/Artist
name or Category name is not
available
ANTENNA
SVC ANT
UPDATING
NO SIGNAL
OFF AIR
LOADING
XM---
--------
----/----
--------