Filter
Top Products
10
Auto Function Selection
Auto Function Selection
• If you press PLAY/PAUSE (
BB
/
[]
) on the remote
control during radio receiving, CD will operate
automatically.
• If you press PRESET ( ) on the remote
control during CD, radio function will operate.
Setting the Clock
Setting the Clock
1.
Press CLOCK.
(If the clock requires setting, press and hold
CLOCK for more than 2 seconds.)
2. Select a 24 hour cycle or 12 hour cycle by
pressing .
bbbb
/
BBBB
> on the front
panel.
3.
Press SET/CD
[]
to confirm the selected hour
cycle.
4.
Use .
bbbb
/
BBBB
> on the front panel to
set the correct hours.
5. Press SET/CD
[]
.
6. Use .
bbbb
/
BBBB
> on the front panel to
set the correct minutes.
7. Press SET/CD
[]
and the correct time is
shown on the display.
8. Press CLOCK at any time to display the time
for about 5 seconds.
Using the
Using the
Sleep
Sleep
Function
Function
When the sleep timer is used, the power is auto-
matically turned off after the specified time has
elapsed.
1. To specify the time delay before the power is
turned off, press SLEEP.
In the display window you see
for about 5 seconds. This means that the
system turns off automatically after 90
minutes.
Press SLEEP until the desired time is dis-
played.
Note: Each time the button is pressed the
time interval is reduced by 10 minutes. i.e.
80...70... etc.
2. To check the remaining time until the power
is turned off, press SLEEP while the sleep
function is active. The time remaining is dis-
played for about 5 seconds.
ote
If you press SLEEP while the sleep time is
displayed, the SLEEP time is reset.
3. To cancel the sleep timer mode, press the
SLEEP button repeatedly until “SLEEP 10”
appears, and then press SLEEP once again
while “SLEEP 10” indicator is displayed.
/
(12HR)
(24HR)
or