Filter
Top Products
8
Installation and Setup
TV Connection
Make one of the following connections, depending on
the capabilities of your existing equipment.
Tip:
• Depending on your TV and other equipment you
wish to connect, there are various ways you could
connect the
unit
. Use one of the connections
described below.
• Please refer to the manuals of your TV, VCR,
Stereo System or other devices as necessary to
make the best connections.
Caution:
•
Make sure the unit is connected directly to the TV.
Select the correct AV input on your TV.
• Do not connect your
unit
to the TV via your VCR.
The DVD image could be distorted by the copy
protection system.
Video connection
Connect the VIDEO OUT jack from the unit to the
VIDEO IN jack on the TV using the video cable
supplied (V).
Component Video connection
Connect the COMPONENT VIDEO OUT jacks from
the unit to the corresponding jacks on the TV using a
YP
b Pr cable (C).
Antenna (Aerial) Connections
Connect the supplied FM/AM antennas for listening to
the radio.
Note:
•To prevent noise pickup, keep the AM loop antenna
away from the unit and other components.
• Be sure to fully extend the FM wire antenna.
• After connecting the FM wire antenna, keep it as
horizontal as possible.
V
C
Y
Pb Pr
COMPONENT VIDEO /
PROGRESSIVE SCAN INPUT
L
VIDEO
INPUT
Rear of TV
FM wire antenna (supplied)
AM(MW) loop antenna
(aerial) (supplied)
For AM(MW) reception,connect
the loop antenna (aerial) to the
terminal marked AM