Filter
Top Products
28
Listening to FM/AM radio
You can listen to FM and AM broadcasts through the
built-in tuner. Before operation, make sure you have
connected the FM and AM antennas to the unit.
Automatic tuning
1. Rotate INPUT SELECT to select tuner (FM or
AM).
Or select TUNER with the remote control to
select tuner (FM or AM).
Tip
Refer to the “Selecting the input source” on the
page 25 to select the tuner mode.
2. Press TUN. - or TUN. + for more than 2
seconds.
Press TUN. - for more than 2 seconds to scan
from high to low.
Press TUN. + for more than 2 seconds to scan
from low to high.
The unit stops scanning whenever a station is
received.
Note
In case of FM stereo reception, if the FM stereo
reception is poor and “ST.” flashes in the display
window, select monaural audio so that the sound will
be less distorted by pressing the MO./ST.
- The “ST.” indicator disappears in the display
window.
There will be no stereo effect, but the reception will
improve. Press the button again to restore the
stereo effect.
Manual tuning
Press TUN. - or TUN. + briefly and repeatedly on
the FM or AM mode to select a station you want.
Presetting radio stations
You can preset up to 50 FM or AM stations.
Then you can easily tune in the stations you often
listen to.
1. Rotate INPUT SELECT to select tuner (FM or
AM).
Or select TUNER with the remote control to
select tuner (FM or AM).
Tip
Refer to the “Selecting the input source” on the
page 25 to select the tuner mode.
2. Tune in the station that you want to preset
using Automatic tuning or Manual tuning.
3. Press PROG./CLEAR.
A preset number flashes in the display window for
a few seconds. When a preset number flashes, do
step the 4.
4. Press PRESET - or PRESET+ to select a preset
number you want.
If a preset number is not flashed before you select
the preset number, start again from the step 3.
5. Press PROG./CLEAR again.
The station is stored to the selected preset
number.
If a preset number is not flashed before you press
PROG./CLEAR, start again from the step 3.
6. Repeat the steps 2 to 5 to preset another
station.
To clear all the stored stations
1. Press and hold PROG./CLEAR for about two
seconds.
“ERASE ALL” appears in the display window.
2. Press PROG./CLEAR again.
All the presetting stations are cleared.
Notes
• If you have accidentally entered into the "ERASE
ALL" mode and you do not wish to clear the
memory, do not press any key. After a few seconds,
"ERASE ALL" will go out by itself and change to
normal mode.
• If all stations have already been entered, “FULL” will
appear in the display window for a moment and
then a preset number will flash. To change the
preset number, follow the steps 4-5 as specified
above. The previous frequency is automatically
refreshed.