Filter
Top Products
IB-HT3917-WM-E-041506
1 After completing all SPEAKER and AUDIO connections, plug the AC power plug into a 120V 60 Hz wall outlet and flip POWER
switch on the back of the main set to ON position, the system enters STANDBY mode and the ON/STANDBY indicator will flash
in red. This plug is polarized, if it does not fit your outlet, do not force it, reverse it and re-insert it.
2 Press the ON/STANDBY button on the front of the main set or on the REMOTE CONTROL to turn the system on and the
ON/STANDBY indicator will be steadily on in green.
NOTE: The ON/STANDBY indicator has 3 modes: flashing in red and in green, and steadily on in green (slow flashing in red
indicates the set is in standby mode; Flashing in green indicates confirming you pressed any button on the main set or on the
remote control and steadily on in green indicates the set is on). When the set is on, pressing the ON/STANDBY button on the
main set or on the REMOTE CONTROL will turn the set to the standby mode, the indicator will become slow flashing in red.
3 Press the SOURCE button on the front panel of the main set or on the REMOTE CONTROL repeatedly to select your desired audio
input sources and the sound will be heard from the HOME THEATER SYSTEM.
4 For SUBWOOFER’s volume adjustment, press the SUBWOOFER volume control buttons on the Remote control:
+ raises the volume, and the ON/STANDBY indicator will flash in green, but at its maximum level, the ON/STANDBY indicator will
stop flashing.
– lowers the volume, and the ON/STANDBY indicator will flash in green, but at its minimum level, the ON/STANDBY indicator will
stop flashing.
Follow this step to adjust the FRONT, CENTER and REAR speakers as well.
5 For MASTER’s volume adjustment (change all the speaker’s volume at the same time), press the VOLUME + or VOLUME –
button on the main set or the MASTER VOLUME control or on the remote control.
raises the volume, and the ON/STANDBY indicator will flash in green, but at its maximum level, the ON/STANDBY indicator
will stop flashing.
lowers the volume, and the ON/STANDBY indicator will flash in green, but at its minimum level, the ON/STANDBY indicator
will stop flashing.
6 To adjust all speaker’s volume to the factory’s default settings, press the RESET button.
NOTE: Every time you turn the set on, the MASTER VOLUME will go back to the factory’s default setting; and whenever you
press the SOURCE button on the main unit or the SOURCE button on the REMOTE, the MASTER VOLUME will go
back to the factory’s default setting. This avoids sudden very loud sounds from startling you.
ON/STANDBY
indicator
SOURCE
button
Remote
sensor
ON/STANDBY
button
MASTER VOLUME
buttons
R
L
DVD IN
AUX IN
OUTPUT
SP EAKER TERMIN ALS 4
LEFT
RIGHT
FRONT
LEFT
RIGHT
REAR
+
T 1.25AL/250V
POWER switch
AC power plug
General
11