Filter
Top Products
IB-CD2036(SY)-WM-E-010805
You can use the AC power or batteries as a power source.
4
To a wall outlet
•
Replace the batteries
when the POWER lamp
dims or when the player
stops operating. Replace
all the batteries with new
ones. Before you replace
the batteries, be sure to
take out the CD from the
player and remember to
check the Battery Safety
Instructions on Page 3.
•
If the CD does not play on
batteries, this means the
batteries are almost used
up. But the radio may
continue to play on these
weak batteries because it
uses less power than the
CD player.
1.Connecting the AC power
Insert one end of the supplied AC power cord into
the socket located at the rear of the set, and the
other end into the 120V, 60Hz standard household
outlet.
2.Using the player on batteries
Insert 6 size “D” batteries (not supplied) into the
battery compartment as shown, observe + and -
polarities.
To use the player on batteries, disconnect the AC
power cord from both the wall outlet and the back of
the player.
BATTERY DOOR
(on the bottom of the set)
CHOOSING THE POWER SOURCES
Install Batteries as illustrated
NOTE:One blade of plug
and outlet is wider.
TIP
•
If the plug of the AC power
cord does not match your
outlet, do not force it.
Reverse it and try again.
The plug is polarized and
only fits one way into the
wall outlet.
DD
D
D
D
D
D
IB-CD2036(SY)-WM-E-010805.PMD 2/23/2005, 2:38 PM5