Lenoxx Electronics CD-1095 CD Player User Manual


 
IB-CD1095(SY)-WM-E-031604
CHOOSING THE POWER SOURCES
You can use the AC power or batteries as a power source.
1.Connecting the AC power
cord
Insert one end of the supplied AC power cord into
the socket located at the rear of the player, and the
other end to the wall outlet.
2.Using the player on batteries
Insert 6 size C batteries (not supplied) into the
battery compartment.
To use the player on batteries, disconnect and
remove the AC power cord both from back of the
player and the wall outlet.
4
Insert new batteries as
shown.
Replace the batteries
when the POWER lamp
dims or when the player
stops operating. Replace
all the batteries with new
ones. Before you replace
the batteries, be sure to
take out the CD from the
player and remember to
check the Battery Safety
Instructions on Page 3.
If the CD does not play
on batteries, this means
the batteries are almost
used up. But the radio
may continue to play on
these weak batteries
because it uses less
power than the CD player.
To a wall outlet
AC SOCKET
NOTE: One blade of the
plug and outlet is wider.
IB-CD1095(sy)-WM-E-031604.p653/18/2004, 2:11 PM5