Lennox Hearth BT2010 Headphones User Manual


 
5
7. Pairing it with your phone
Headsets are connected to phones using a procedure called ‘pairing’. By
following a few simple steps, a phone can be paired with a headset in a
matter of minutes. ( See g 3)
1. Put the headset in pairing mode
• When you turn on your Jabra BT2010 for the rst time, the headset will
automatically start up on pairing mode – i.e. it is discoverable for your
phone. When the headset is in pairing mode the LED is constantly lit.
2. Set your Bluetooth phone to ‘discover’ the Jabra BT2010
• Follow your phone’s instruction guide. First make sure that Bluetooth is
activated on your mobile phone. Then set your phone to discover the
headset. This usually involves going to a ‘setup,’ ‘connect’ or ‘Bluetooth’
menu on your phone and selecting the option to ‘discover’ or ‘add’ a
Bluetooth device.*
3. Your phone will nd the Jabra BT2010
• Your phone will nd the headset under name “Bluetooth headset”.
Your phone then asks if you want to pair with the headset. Accept by
pressing ‘Yes’ or ‘OK’ on the phone and conrm with the passkey or PIN
= 0000 (4 zeros). Your phone will conrm when pairing is complete.
In case of unsuccessful pairing, put the Jabra BT2010 into pairing mode
manually. Make sure the headset is o. Press and hold the answer/end
button for approximately 5 seconds until the LED has a constant light.The
LED will ash before the light is constant – keep holding down the button
until light is constant.
1 2
g 3