Lennox Hearth BT2010 Headphones User Manual


 
4
5. Charge your headset
Make sure that your headset is fully charged for 2 hours before you start
using it. Use the AC power supply to charge from a power socket. When the
light indicator (LED) has a solid LED light, your headset is charging. When
the solid LED light turns o, it is fully charged. (See g 2)
Use only the charger provided in the box - do not user chargers from any
other devices as this may damage your headset.
Please note: The lifetime of the battery will be signicantly reduced
if your device is left uncharged for a long period. We therefore
recommend that you recharge your device at least once a month.
6. Turning your headset on and o
Press the answer/end button until you see a burst of ashes on the
indicator light (LED) to turn on your headset.
Press and hold the answer/end button until you see a burst of ashes
on the indicator light (LED) to turn the headset o.
Please note that the LED indicator light turns o after 1 minute to save
battery. Headset is still active, and light will ash again after tap on the
Answer/End button or any call activity. To check if the headset is on,
tap the answer/end button once – the LED indicator light will ash, if the
headset is on.
g 2
1 2