Filter
Top Products
8
Status Item 05 – NET TX 2 Status (Idle or Number of Receivers)
Same as above for net outputs 9-16.
Status Item 06 – NET TX 3 Status (Idle or Number of Receivers)
Same as above for net outputs 17-24.
Status Item 07 – Conductor Status (Another Unit or This Unit)
Indicates if the network conductor ('sync generator') is this unit or not.
Status Item 08 – PCB Temperature ( degrees Celsius)
Indicates temperature of sensors on main PCB. Normal temperature is in the 35-45
degree range. A high temperature indication might indicate a fan failure, and will
cause a fault message to be displayed if the temperature exceeds 55 degrees.
Status Item 09 – Output Reference (Int or Ext)
This status item indicates the sync reference for the AES outputs. The ADX-2400
will lock the outputs to an external AES reference if that reference is present, and
this status item will indicate EXT. If there is no external AES reference signal
connected, the ADX-2400 will lock the outputs to the network (Cobranet) clocks.
This status item will indicate INT.
Status Item 10 – System ID (00-99)
Displays two-digit system (frame) ID, as determined by the rotary switches on the
front edge of the pcb, behind the front panel. These two digits are used as the last
octet of the network IP address (192.168.100.xx), and the last part of the Cobranet
system name (Lance ADX2400D-xx). This IP address and system name appear
when using the Cobranet 'Discovery' application to report network node status.
Status Item 11 – Firmware Version
Displays the version and date of the installed firmware.