Filter
Top Products
1/2" FPT
1/2" FPT
1/2" FPT
1/2" FPT
1/2" FPT
1/2" FPT
Inlet:
hot
water
Inlet:
cold
water
Inlet:
hot
water
Inlet:
cold
water
Inlet:
hot
water
Inlet:
cold
water
!
!
!
MINIMUM
MAXIMUM
MINIMUM
MAXIMUM
K.37.P4.02
K.37.P4.01
MINIMUM
MAXIMUM
M
I
N
I
MUM
M
AXIMUM
M
I
N
I
MUM
MAXI
M
UM
K.37.P4.03
MINIMUM
MAXIMUM
102mm
4"
39mm / 1 17/32"
67mm
2 5/8"
70mm
2 3/4"
70mm
2 3/4"
86mm
3 3/8"
180mm / 7 1/8"
179mm / 7 1/32"
96mm / 3 25/32"
180mm / 7 1/8"
81mm /
3 3/16"
100mm /
3 15/16"
58mm / 2 9/32"
39mm / 1 17/32"
58mm / 2 9/32"
1150mm
45"
1980mm
78"
840mm
33"
810mm
32"
Shower only Tub / shower
Floor
line
1170mm
46"
179mm / 7 1/32"
96mm / 3 25/32"
Standard installation:
Back-to-back installation:
!
140mm /
5 1/2"
+
/
1
2
Rough inStandard installation
Back-to-back installation
Dimensions
Back-to-back installation:
In back-to-back installations, cartridge must be
rotated 180° to ensure proper valve operation.
3 port valve, shower only:
Position valve with outlet up. Finished wall must be within the
dimensions shown on finished wall template.
4 port valve, tub and shower:
Position valve with shower outlet marked "S" up and the tub outlet
marked "T" down.
Finished wall must be within the dimensions shown on finished wall
template.
Finished wall template must remain intact for finished
wall surface measurements and as a template for
plastering and / or tiling.
It is not necessary to remove the pressure balancing
cartridge from the valve during normal soldering of
connections, using propane-butane gas. Do not use
OXYGEN-ACETYLENE!
When soldering connections, do not use excessive
heat!
To test the pipe joints, pressurize both hot and cold
inlets!