t
u
v
w
x
y
z
{
|
}
Circuit Breaker:
Power Cord
Speaker Outputs
Ground Lift Switch
Direct Output Jack
Pre EQ / Post EQ Switch:
Tuner Out Jack:
Effects Send Jack
Effects Return Jack
Footswitch Jack:
:
:
Use
:
:
:
:
This circuit breaker will trip when too much
current is applied to the amplifier. To reset: Turn
off , press circuit breaker button,
and turn the on. Note: If the
Circuit Breaker trips repeatedly when AC power
is applied, take the amplifier to an authorized
service center for repair.
This supplies AC power to the amplifier. If the
cord becomes damaged, take the amplifier to an
authorized service center for repair.
these jacks to connect the amplifier to
speaker cabinets using heavy duty Speakon
speaker cables. These jacks are connected
together internally. See
(Page 8) for speaker cabinet loading
information. To prevent overheating and
possible loss of signal, do not connect a load
lower than 2 ohms. (To connect a cable: Align tab
on speaker cable connector slot. Insert and twist
one quarter turn clockwise to lock. To remove a
cable: Pull back release button on cable connector,
twist connecter counter clockwise one quarter
turn, and pull out connecter.)
Activating this switch removes the ground
connection on the .
Removing the ground connection will eliminate
related signal hum.
This is a line level output used to connect the
amplifier to another device, such as a mixer or
recorder.
When set to Pre EQ, the signal
will be unaltered by the EQ sections of the preamp.
When set to Post EQ, the
signal will reflect the entire sound (including EQ
settings) of the preamp. The
and have no effect on
the signal.
Use this jack to connect to a tuner or other line level
device. This jack is always active and is a pre-gain
output.
Use this jack to connect to the input of an external
effects processor. This jack can also be used as a
preamp out.
Use this jack to connect to the output of an external
effects processor. This jack can also be used as a
power amp in.
This 3-conductor 1/4” jack may be used for
connecting a footswitch to the amplifier
(Footswitch model KAC-GFS100 is included with
the amplifier). The footswitch will then control the
Mute and Solo features.
Power Switch
Power Switch
Amplifier Loading
Chart
Note:
Direct Output Jack
Direct Output Jack
Direct Output Jack
Note: Master Volume
Control Solo On/Off Button
Direct Output Jack
d
7
Rear Panel
25
DIRECT OUTPUT
SPEAKER OUTPUT
EFFECTS LOOP
SEND
RETURN
FOOTSWITCH
TUNER OUT
GROUND
LIFT
POST EQ
PRE EQ
DESIGNED IN USA
MADE IN CHINA
SERIAL NUMBER
MODEL:GROOVE1200
2001124
ATTENTION
RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
RISK OF ELECTRIC SHOCKRISK OF ELECTRIC SHOCK
DO NOT OPENDO NOT OPEN
CAUTION
CHASSIS SURFACE HOT
ATTENTION
SUPERFICE DE CHASSIS CHAUDE
BREAKER
1
5
A
1
5
A