Filter
Top Products
Audio Input
10kohms Balanced
Pin 2 + Tip = High
Pin 3 + Ring = Low
Pin 1 + Sleeve = Ground
Connecting Your System
IMPORTANT: All connections should be made, all fader
and controls should be set at their minimum levels, and
all other equipment should be powered prior to powering
up your RoKit G2 monitors.
NOTE: Ensure that the voltage indicator found in the voltage
selector is set to the correct voltage setting for your local supply.
Powering On
The power On/Off switch is located on the rear panel. The KRK
logo on the front face plate illuminates when power is applied.
Changing Voltage
To change the voltage, remove the power cord and slide the
voltage selector to the desired voltage setting. Please note that
when making voltage changes, the fuses will have to be replaced
(refer to the Changing Fuses section below).
Changing Fuses
Under normal operation the fuses should not blow. A blown fuse
usually indicates an overload or fault condition. To change the
fuse, remove the power cord, pry off the fuse block with a small
flathead screwdriver and change the blown fuses. Refer to the
Specifications section for fuse current ratings.
NOTE: If the fuses blow immediately upon power up, this
indicates a fault condition and the monitor should be returned to
KRK for repair.
Audio Inputs
The XLR and TRS inputs are balanced while the RCA input is
unbalanced.
Unbalanced
Balanced
8