Filter
Top Products
Krell S–1000 59
Operating the S–1000, continued
Tape Input and Output,
c
ontinued
Notes
3. Use the tape output to create a processor loop, when the S–1000
is connected to a graphic equalizer or other ancillary equipment.
Connect the equipment to the S–1000 tape outputs (34) as
described in the equipment manufacturer’s manual. Press the tape
button (15) or key (64) to switch between the processor output
(LED illuminated) and the input source (LED not illuminated).
The tape output functions only with analog sources.
There is no tape output from the 7.1 multi-channel input.
When changing sources, lower the volume to off or mute the output. This
ensures that the next source played does not damage your system with a
high output transient.
When you are listening to or viewing different devices that have dif-
ferent trigger settings (configured through the setup menus), you can
retain a trigger setting using the previous (30) key.
For example, you have configured the S–1000 to turn on the TV
monitor when trigger 4 is on and the CD player is set for TRIGGER 4
OFF. You want to watch TV and listen to a CD at the same time. If
you press the TV button or key followed by the CD button or key,
the TV monitor will turn off.
To keep the monitor on and turn on the CD player, follow these
steps:
1. Press the TV button or key (9) to select the device. Begin playing
the device.
2.
Pr
ess the pr
ev key (30).
3.
Pr
ess the CD button or key (10). Begin playing the device.
SIMULCAST