Filter
Top Products
NAVIGATION
CONVENTIONS
Overview: System Configuration and Navigation, continued
Krell S–1000 23
The remote control is the main input device for configuring the
S–1000. For all menu mode options, use the following keys to navi-
gate through the configuration menu screens:
29 Menu Key
Press this key once to enter the configuration menu. The front
panel display reads
MENU MODE. The MAIN MENU screen appears.
Press this key again to exit the configuration menu. The S–1000
reverts to the operational mode.
33 Direction or Level Keys
Use all four directional keys to navigate the on-screen menus.
32 Enter Key
Press this key once to select a highlighted item. Once an item is
selected, use the direction or level keys (33) to scroll through
available options within a line. T
o select a highlighted option
within a line, press the enter key again.
30 Pr
ev Key
Press this key once to r
eturn to the previous screen within the
configuration menu.
1 Pre Key
The power key for the S–1000 is marked: Pre on the remote. In
the menu mode it is used to exit the configuration menu. Press
this key once. The S–1000 reverts to the stand-by mode.
When a menu screen first appears, and there is a cursor blinking at
one menu item, press the enter key (32) to select the menu item. If
the item is configurable, the entire selection blinks along with the
cursor.
Then use the direction keys (33) to scroll through the options that are
blinking. Press the enter key to set your selection. After you have set
the selection, the selection stops blinking and only the cursor at the
menu item is blinking. Use the direction keys to move the cursor to
the next menu item.
To Select and Enter
Menu Options