Filter
Top Products
This supply does not’ require that an AC circuit be dedicated for its use
only. It should be connected to a 15 or 20 amp circuit that is dedicated for
the source components and preamplifier. Do not connect this supply to
the mains with light-gauge (18 or higher) extension cords or multiple
outlet adapters. AC extension cords, outlet strips and good quality surge
protectors that are rated for 15 amps and are grounded are acceptable.
b. Preamplifier Location Guidelines
The KSP-7B chassis measures 18 3/8" wide, 13 1/2" deep and 2" high.
Four inches clearance should be allowed above the top of the KSP-7B.
Only a small amount of clearance is needed on the sides. Four to six
inches clearance should be allowed at the rear of the unit to provide for
cables.
c. Power Supply & Preamplifier Installation
i. Place the power supply in location.
ii. Place the preamplifier in location.
iii Connect the DC cable from the supply to the preamplifier.
iv. Do not plug the AC connector into the mains at this time, but make
certain the cable length is adequate.
3. Connection of Inputs and Outputs
All source components should be off at this point.
a. Connection of Inuut Sources
Follow the markings on the rear panel for proper input assignments.
Make the connections between the source components and preamplifier
inputs at this time.
b. Connection of Record Outuuts
There is one set of Record Outputs which receive the signal from the
input chosen on the Select switch for sending to a tape deck. Make the
connections between the Record Outputs and tape deck at this time.
c. Connection of Main 0~tputs
There are two sets of Main Outputs: one set single-ended using RCA
connectors; one set balanced using XLR connectors. They are wired in
parallel and can be connected and operated simultaneously. There is no
degradation to either output if both are connected, whether one or both
are in operation at the same time. You may even choose to drive two
independent systems from your KSP-7B.
6