Filter
Top Products
Krell KAV–2250 and KAV–3250 15
Reconfiguration Options for the KAV–2250
and KAV–3250
There are a number of options for reconfiguring the amplifier output:
Multi Amp Throughput (MAT)
is an internal connection option for the amplifier that lets
you send the same music signal to all amplifier channels using one balanced or single-
ended connection. MAT reduces installation complexity and cabling requirements in
systems containing multiple amplifiers.
Bridging
allows you to reconfigure two channels to operate as one combined amplifier
channel. The bridged amplifier channels deliver 1,000 Watts into an 8 Ohm load. The
remaining unbridged amplifier channel on the KAV–3250 can be connected to a
separate loudspeaker.
To reconfigure the amplifier for MAT or for bridged operation you need to remove the
top cover of the amplifier and access the input switch banks.
IMPORTANT
Removing the cover of the amplifier to reconfigure for MAT or for bridged operation is
the
ONLY
instance you are authorized to remove the cover of
ANY
Krell component
without voiding your Warranty. For more information on product limitations and
restrictions, see
Warranty,
on page 24.
TO SAFELY ACCESS THE INPUT SWITCH BANKS
Before reconfiguring the amplifier, please read the following important instructions to
safely remove the amplifier cover and access the input switch banks to reconfigure the
KAV–2250 or KAV–3250.
Tool needed: T-15 Torx wrench
1. Unplug the AC power cord from AC power.
2. Krell suggests removing jewelry before reconfiguring your amplifier. Rings,
necklaces, bracelets, and other metal jewelry can conduct an electrical charge.
3. Using the T-15 Torx wrench, remove the 12 screws that secure the amplifier cover.
4. Carefully remove the cover.
5. Locate the green input circuit board, which has white input switches and red input
switch banks, at the rear of the amplifier