Filter
Top Products
C. FCC COMPLIANCE STATEMENT
WARNING: Changes or modifications to this unit not
expressly approved by the party responsible for compli-
ance could void the user’s authority to operate the equip-
ment.
Note: This equipment has been tested and found to com-
ply with the fimlts for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residentiaf installation. This equipment gener-
ates, uses, and can radiate radio frequen.cy.energy and, if
not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television recep-
tion, which can be determined by turning the equip.ment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult your dealer or an experienced radio/TV
technician for help.
The user may find the following booklet prepared by the
Federal Communications Commission helpful:
"Television Interference Handbook"
This booklet is available from the U.S. Government
Printing Office, Washington DC 20402.
Stock No. 004-000-00450-7
WARNING: The use of non-shielded analog output
cables and non-shielded digital input cables ff coax is
used for the digital input (6ptics intercg~.nnect nee_d.not be
Shielded) will ~nvalidate the FCC Certification ot this
device and may cause interference lev.els which exceed
the limits established by the FCC for this type of device.
3