Filter
Top Products
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using the VP-411DS 4x1 Automatic UXGA / Audio Switcher
10
5.3 Connecting the REMOTE Connector
The contact closure remote control pins operate in a similar way to the Input
selector button. Using the contact closure remote control you can select the
UXGA input or cut off the inputs. To do so, temporarily connect the required
input
1
pin on the REMOTE terminal block connector to the GND (Ground) pin,
as Figure 5 illustrates.
DO NOT connect more than one PIN to the GND PIN at the same time
To select IN 2,
connect the 2 PIN
to the G PIN
To select IN 3,
connect the 3 PIN
to the G PIN
To select IN 1,
connect the 1 PIN
to the G PIN
To select IN 4,
connect the 4 PIN
to the G PIN
To select OFF,
connect the OFF
PIN to the G PIN
Figure 5: Connecting the Contact Closure Remote Control PINs
1 IN1, IN 2, IN 3 IN 4, or OFF