Filter
Top Products
CONTENTS
16
Installing
Calibration Files
1.4 Installing Calibration Files
The CA-2000 you have purchased comes with a calibration data DVD for each lens you selected at time
of purchase.
All items on the DVD provided must be installed in order for the CA-2000 to make measurements.
To install the calibration files, be sure to log on as an administrator to the PC.
Note
If you selected a user other than a user with administrator privileges, you cannot install the
calibration files.
Note
If you are installing calibration files for the first time, you need to run the CA-S20w as an
administrator. To do this, right-click ‘CA-S20w’ from the program menu and select ‘Run as
administrator’.
1.4.1 Installation Method
1. Start the software.
The Connect CA-2000 dialog box appears.
2. Select ‘Disconnect’ and click the OK button.
3. Select Tool - Install calibration files from the menu.
4. When the Insert calibration-DVD message dialog box appears, insert the calibration data DVD in
the drive and click the OK button.
Insert the disk in the drive recognized first.
After inserting the disk, the message may be displayed several times. Click the OK button each time
it appears.
Installation starts when the disk is recognized. Installation takes about 3 minutes.