Filter
Top Products
10
11
Answering a VoIP call
Press .
The Konftel 300 has now been put into call mode and the LEDs show a steady blue light.
Indicate whether you want to start the call by answering in the computer’s VoIP
software.
The Konftel 300 functions as a speaker and microphone for the computer.
Ending a VoIP call
End the call in the computer’s VoIP software and put the Konftel 300 on stand-by
by pressing .
The Konftel 300 now only functions as a speaker for the computer.
CALLS VIA DECT AND GSM PHONES
For these instructions, it is assumed that the Konftel 300 is connected to a DECT or
GSM telephone via a cable (optional accessory). Hereafter, both types of telephone are
referred to as mobile phones.
Select mobile as the telephone line
Press LINE MODE and use the arrow buttons to select MOBILE as a phone line.
Press OK to conrm.
If you select MOBILE+USB as the line mode in the Konftel 300, you will be able to
combine the call with a call connected via the computer (see page 9).
Making calls using a mobile phone
Press and dial the number on the mobile phone as you normally would.
The Konftel 300 now functions as a speaker and microphone for the mobile phone. The LEDs
show a steady blue light.
Ending calls
Ending the call on the mobile phone.
Press to turn off the Konftel 300.
ANSWERING AND MAKING CALLS
ADJUSTING THE SPEAKER VOLUME
Adjust the speaker volume using the buttons and .
Adjusting the speaker volume when two lines are connected
If you have selected double lines, you can adjust the volume level for each line. This is
useful if the lines have different volume levels.
Press the button or the button to display the current volume setting.
The current main volume appears on the display screen. Above it are two smaller
volume indicators which can be used to adjust the two connection lines.
Increase or decrease the speaker volume for both lines in the normal way, using the
and buttons.
Use the arrow buttons to mark either of the connected lines.
Select a line and adjust its speaker volume using the and buttons.
PLACING CALLS ON TEMPORARY HOLD
Mute
Press (Mute) to turn off the microphone.
The LEDs change from blue to red. The other party cannot hear what you are saying.
Press (Mute) to reconnect the call.
Hold
Press HOLD to put the call on hold.
The LEDs change from blue to ashing red. Both the microphone and the speaker are turned off
and the call is on hold.
Press HOLD to reconnect the call.
ENDING CALLS
End the call by pressing .
DURING A CALL