Filter
Top Products
- 8 -
Plug the SCART-CINCH adapter (2)) into
the SCART socket of your TV. Connect
the receiver to the other connector power
pack using the 6 V DC connection socket
(j).
Connect the connector power pack
(2@) with a 230V
~
/50 Hz wall socket.
Use the "ON/OFF" switch (g), which
is located on the side, to switch on the
receiver (f).
Important!
The transmission channel
switch (o) and the reception
channel switch (l) must be
set to the same channel.
Otherwise radio transmission
is not possible.
Rotate the antenna for transmission of the
remote control signals (s) upward.
Orient the audio/video reception an-
tenna (h) for the best image and sound
quality. The unlabelled side of the antenna
should point in the direction of the trans-
mitter (e).
Important!
If necessary, try positioning the receiver
(f) in a dierent location to avoid
interference eects.
Switch on your TV.
You can use the following connection
options on your TV.
The AV socket (SCART/CINCH
•
connection)
Point the remote control of the transmission
source at the infrared receiver (d) of the
receiver (f). The commands are sent to
your transmission source.
Improving the transmission quality
You can try the following measures to im-
prove the quality in event of transmission
disruptions:
Orient the audio/video transmitter
•
antenna or reception antenna (a, h)
dierently.
Change the location of the transmitter
•
(e) and/or the receiver (f).
Change the position of the transmission
•
diodes of the infrared cable (2#) on
the infrared receiver of the transmission
source. The remote control signal quality
is improved.
Try a dierent channel, either A, B, C
•
or D.
Depending on the image source (DVD
•
player, SAT receiver, VCR, etc.) and
the image contents (with large bright
areas), overpowered video signals
may occur in combination with certain
TVs. These appear as distorted images.
In this case, you can use the local TV
switch (i) to adjust the transmission
level and eliminate the distortions.
Transmitter connection examples
Note:
In general:
You can transmit signals from any
device that outputs a sound and/or
video signal on an appropriate
connection:
• CD player
• DVD player
• VCR
• Television
• SAT receiver/set top box
• Video camera
• PC graphics card