Filter
Top Products
17
Handling and operation
SKRD 30 A1
GB
CY
Programming alarm wake times
The device has two alarms available. All settings for both alarms can be carried
out independently from each other. You can select whether at the programmed
time an alarm tone shall sound or the radio shall play.
NOTICE
If, during alarm wake programming, no button is pressed for approx. ►
15 seconds the alarm will activate with the current settings.
Pr
erequisite: The device is in the operational mode clock/standby operation.
To set the wake time proceed as follows:
Press the Alarm1 button ♦
8
or the Alarm2 button
9
. The set wake time
of the respective alarm is shown blinking in the display
3
and the indicator
A1 and/or A2 appears. The weekday on which this alarm is to be activated
is shown above the time indicator.
Set with the buttons Tune+ ♦
13
and Tune–
12
the desired wake time. With
each button press the wake time changes by one minute. Holding down the
respective button for more than 2 seconds starts the speed setting.
Press the button AOT ♦
5
to switch between the weekday combinations Mo-Fr,
Sa-Su or Mo-Su. The respective selected combination is shown above the
wake time.
Press and hold down the button AOT ♦
5
for at least 2 seconds to switch
between the weekday combinations and individual weekday setting alterna-
tives.
NOTICE
With the individual weekday setting alternative you switch between ►
the days of the week with the button AOT
5
.
Wake with alarm tone
Prerequisite: The device is in the operational mode clock/standby operation.
To select "Alarm tone" for the respective alarm press the Alarm1 button ♦
8
or the Alarm2 button
9
several times in succession until, in the display
3
,
the symbol
appears.