Filter
Top Products
- 7 -
Setting the time
1. While in standby mode, depress the button CLOCK
SET for more than two seconds.
The time display will start to flash.
2. Within the next 10 seconds use the pushbutton
BACK and NEXT ( and on the remote control)
to set the time in either 24-hour or 12-hour mode.
In the 12-hour mode the morning hours are displayed
as AM.
3. Press the pushbutton
CLOCK SET to acknowledge
this setting.
The hour-display now blinks.
4. Within the next 10 seconds use the pushbutton
BACK and NEXT ( and on the remote control)
to set the hour of the day.
5. Press the pushbutton
CLOCK SET to acknowledge
this setting.
The minute-display now blinks.
6. Within the next 10 seconds use the pushbutton
BACK and NEXT ( and on the remote control)
to set the minutes.
7. Press the pushbutton
CLOCK SET to acknowledge
this setting. The time display is now programmed.
In order to ensure a continuous display of the clock,
even after a power failure or after the mains cable
has been removed, please insert the back-up batteries.
Utilisation
Operating the pushbuttons on the
device and on the remote control
Most functions can be activated by pushing the
buttons on the device itself or on the remote control.
These instructions only describe the pushbuttons of
the device. Any reference to the pushbuttons on the
remote control will be specifically highlighted.
Switching the device on and off
• To turn the Micro System on, please push the
STANDBY button, either on the device itself or on
the remote control unit.
The green standby LED extinguishes and the display
is being illuminated.
• To switch the device back into the standby
mode, press the button
STANDBY again.
• If you would like to completely shut off the device,
remove the power cable from the mains.
Adjusting the volume.
• In order to increase the volume, press the pushbutton
VOL. UP on the device (VOL+ on the remote control
unit).
• Press the pushbutton
VOL. DN on the device (VOL- on
the remote control), in order to reduce the volume.
Switching off the sound
• To switch the sound completely off, press the
button
MUTE on the remote control.
• To turn the sound back on, press the button
MUTE
again or press the the button VOL. UP/VOL. DN (VOL+/-
on the remote control).
Selecting the sound source
After you turned on the device, use the button
CD/MP3, AUX or RADIO to select the sound source you
would like to play back:
CD/MP3: Audio-/MP3-Disc playback
AUX : External sound source
RADIO: Radio operation
Radio functions
• Set the reception range (AM/FM) by using the
button
BAND. The respective reception range
together with the frequency will be displayed
for approximately 5 seconds. Subsequently,
the time is displayed again.
• In order to switch between frequency and time
display press the pushbutton
DISPLAY.
Setting the radio frequency
1. Set the desired radio station by rotating the
tuning knob. The frequency will be shown in
the display.
IB_KH2306_AR23605_LB6 18.08.2008 16:23 Uhr Seite 7