Filter
Top Products
If range
does not operate
Check that the circuit breaker is not
tripped or the house fuse blown.
Check that gas valves are turned to
the “ON” position.
See Use and Care Guide for
troubleshooting list.
✓
✓
✓
Installer checkoff
list
Range correctly positioned in
countertop cutout.
Maintained specified distances to
cabinet surfaces.
Range level – front to back – side to
side.
Burner caps positioned properly on
sealed burner bases.
All packing material removed.
Backguard or island trim attached
(see page 3).
Depending on model, grille parts
correctly assembled.
Depending on model, griddle parts
correctly assembled.
✓
✓
✓
✓
✓
✓
✓
✓
If you need
assistance
The KitchenAid Customer Interaction
Center will answer any questions about
operating or maintaining your range not
covered in the Installation Instructions.
The KitchenAid Customer Interaction
Center is open 24 hours a day, 7 days a
week. Just dial 1-800-422-1230 — the
call is free within the continental United
States, or visit our web site at
www.kitchenaid,com.
When you call, you will need the range
model number and serial number. Both
numbers can be found on the
model/serial rating plate located on the
surface below the control panel.
If you need
service
In the event that your KitchenAid
appliance should need service, call the
dealer from whom you purchased the
appliance or a KitchenAid-designated
service company. A KitchenAid-
designated service company is listed in
the Yellow Pages of your telephone
directory under “Appliances — Household
— Major — Service and Repair.”
You can also obtain the service
company's name and number by dialing,
free within the continental United States,
the KitchenAid Customer Interaction
Center telephone number, 1-800-422-
1230. A special operator will tell you the
name of your nearest KitchenAid-
designated service company.
Maintain the quality built into your
KitchenAid appliance — call a
KitchenAid-designated service company.
Maintenance
If removing the range is necessary for
maintenance, shut off gas supply.
Disconnect the gas and electric supply.
Finish removing the range.
10
RANGE
The range is connected only to type
of gas for which it is certified for use.
✓
GAS SUPPLY
L1 N
W
W
GROUND
GRN
W
BKBK
W
LNG
W
SPARK
MODULE
GRILLE
VALVE
YEL OR
BRN
4 PLCS
SURFACE BURNER
VALVE
SWITCHES
120 VAC 60 Hz
1 PHASE
15 OR 20 AMP
BK W
GRILLE
IGNITOR
GRILLE
VALVE
SWITCH
SURFACE BURNER
IGNITOR
ELECTRODES
BK
BK
W
W
Cooktop schematic
with grille
L1 N
W
W
BK
GROUND
GRN
W
W
SPARK
MODULE
GRIDDLE
VALVE
120 VAC 60 Hz
1 PHASE
15 OR 20 AMP
BKBK
W
LNG
YEL OR
BRN
4 PLCS
SURFACE BURNER
VALVE
SWITCHES
GRIDDLE
THERMOSTAT
BK
W
SURFACE BURNER
IGNITOR
ELECTRODES
GRIDDLE
IGNITOR
W
W
BK
Cooktop schematic
with griddle