Kicker SKM10 Speaker User Manual


  Open as PDF
of 4
 
4 5
PERFORMANCE
INSTALLATION
Note: The use of a subsonic filter will significantly increase the power handling.
The power handling specifications in these charts are calculated using a 25Hz, 24dB per octave subsonic filter.
*Power Handling Watts RMS without subsonic filter: SKM10-125
Wiring
Remove the cover for the speaker terminal cup, plug your subwoofer speaker wire into the
terminals, using the red connector as positive and the black connector as negative. Connect
the other end of the wire to your subwoofer amplifier in accordance with its owner's manual.
Replace the cover for the speaker terminal cup, by snapping it into place. See Figure 7.
SKM10
4
300 (150)
8 5/16 (21.1)
16 1/16 (40.8)
23 15/16 (67.4)
Performance
Model:
Nominal Impedance [Zn], ohm [per enclosure]
Power Handling
* Watts, Peak (RMS)
Enclosure Depth, in (cm)
Enclosure Height, in (cm)
Enclosure Width, in (cm)
SafetyWarning
To avoid potential injury, or possible death, from forward movement of the enclosure during
abrupt stops or accidents, the enclosure must be properly installed and securely fastened to
your vehicle. You are solely responsible for securely fastening the enclosure in your vehicle.
Figure 5
Figure 6
Subwoofer firing
into the wall
or floor
Mounting
Flange
exposed
Subwoofer firing
away from the
wall or floor
Mounting
Flange
tucked
under the
enclosure
Figure 7
Kicker Marine speakers use the highest level of magnetic shielding available to minimize compass and gauge deviation in your dash.
Kicker Marine speakers meet or exceed industry standards for environmental humidity and corrosion,
and for material degradation due to UV exposure.
KMCOAXIALSPEAKER
Speaker Terminal
Cup Cover
 previous