Filter
Top Products
6
Installation
Comp Subwoofer Enclosures
Truck Enclosures
The TC Series vented truck enclosure combines KICKER’s
award winning Comp subwoofer with a computer-modeled and
human fine-tuned enclosure to offer a level of bass performance
never before thought possible from a commercially available,
ready-to-install subwoofer system. The TS Series enclosure is
available with a pre-loaded 10 inch Comp subwoofer.
To get all the amazing performance potential from your new
enclosure, you need to follow some basic rules. Please read
these instructions carefully. Then, you will be ready to install the
subwoofer enclosure and be on the road and “Livin’ Loud™”.
Kicker TC Series enclosure is designed to fit behind the seat of
a pickup truck. It is engineered to provide the best bass response
when firing into the back of the truck seat.
Mount Brackets with supplied screws
on each side of the DC enclosure
Truck Seat
Door Frame
Floor Board
TC
CAUTION: These enclosures are internally wired for a 2 or 4
ohm load at the speaker-wire connection terminal. Please refer
to the terminal or the box packaging for your enclosure’s specific
impedance. Make sure your amplifier can drive this load.
Plug your subwoofer speaker wires into the terminals. The red
connectors are positive and the black connectors negative. Hook
the other end of these wires to your subwoofer amplifier in
accordance with the amplifier’s manual.
WARNING: To avoid potential injury, or possible death, from forward
movement of the enclosure during abrupt stops or accidents, the
enclosure must be properly installed and securely fastened to
your vehicle.
All specifications and performance figures are subject to change. Please visit kicker.com for the most current information.
DC