Filter
Top Products
Installation
Door Body
Tweeter
Mounting Nut
2" Hole
Door Panel
Clearance Hole 2.5"
Figure 3 (Flush Mount)
Tweeter Mounting
The tweeter can be mounted one of four ways: flush, surface, angled and coaxial mounting. For flush mounting applications, please
refer to the illustration in Figure 3. Mount the tweeter as high up on the door and as far forward as possible without interference from
the dashboard. Choose a flat location on the door with space behind the panel to allow room for the mounting nut.
After checking the clearances, cut a 2” (5.1 cm) hole in the door panel. Place the mounting nut behind the door panel. Feed the
wire through the door and body panels. Mount the tweeter by screwing the tweeter onto the mounting nut.
For surface mounting applications, remove the tweeter face plate by screwing it off and install the supplied smaller face plate. Use
the surface mount cup as a template and drill a 7/64” (2.8 mm) hole in the center for attaching the cup to the door and a 5/16”
(7.9 mm) hole for the wires. A #8 flathead sheet metal screw is supplied to attach the surface mount cup to the door panel. Position
the tweeter over the surface mount cup and press it into position.
7
Installation
KS-Series System Components