Kenwood XD-6550 Stereo System User Manual


 
XD-8550/XD-6000 (En/T)
54
Preparation sectionBasic sectionApplication sectionKnowledge sections
3
2
Convenient CD recording
Recording preparations are required.
¤¤
¤¤
¤
For the reverse mode, select “
”,“
[
” (two-way recording).
1
Press so that the “PGM” indicator lights.
÷Select CD tracks so that their total playing time does not exceed the
recording time of the tape.
÷Up to 32 tracks can be programmed. When “FULL” is displayed, no
more tracks can be programmed.
÷If you make a mistake, press the CLEAR key and enter the track No.
from the beginning.
÷When the P.MODE key is pressed without selecting a title after
selection of a disc, all titles of the disc are programmed, so that the
CCRS function does not operate. Please begin again from step 1.
÷The REPEAT key is invalid.
Recording favorite tracks from CD onto a single tape
(Program edit recording)
Use the following procedure to record CD tracks in the order programmed by yourself so that no tune is interrupted in the
middle at the ends of tape sides.
The tune interrupted at the end of tape side A is erased and side B starts from the beginning of that tune.
Enter disc Nos. and track Nos. in the order you want to record them. (Editing)
1Enter the disc No. (DP-MH5 only)
For XD-6000:
Program other tracks by repeating steps 2 and 3 for each.
3Press the P.MODE key to enter the
selection in memory.
Start edit recording.
PGM
MEMO
EDIT RDS EON TA NEWS INFO. TP PTY TOTAL SPACE
AUTO
TUNED
DISC ALL
STEREO
kHz
MHz
MUTE
12
PROG.
N.B.
CD*)3*P-): 1
1
2
3
4
5
11
12
13
14
15
6
7
8
9
10
MAX
÷The recording level and bias will be adjusted automatically in approx. 60
seconds (variable depending on CD contents), after which recording
starts.
÷For XD-8550: In editing from more than one CD, the CCRS setting
operation is performed after every disc change. In this case, the deck stops
automatically and restart recording after having completed the CCRS
operation.
PGM
MEMO
EDIT RDS EON TA
AUTO
TUNED
DISC ALL
STEREO
CD*
MAX
SLEEP O.T.T
Lights
P.MODE
PTY
SEARCH
231
564
897
0 +10
Go to step 2 within 8 seconds.
Press the numeric keys as shown below....
To enter track No. 23 : 003
To select track No. 40 : 0000)
CCRS
2Enter the track No.
DISC SKIP
When equalizer, SRS 3D or another effect is applied
to the sound, the sound with the applied effect can
be recorded.
OP
Go to step
3 within
8 seconds.
For XD-8550:
If you program tracks from more than one CD, repeat steps 1
to 3 for each.
To check the edited contents Y
To clear the edited contents Y
O p π
1. When the CCRS key is pressed during playback of CD, the playback stops and the CCRS setting (preparation for edited recording) starts.
2. Edit recording is not possible with CDs containing a track that is longer than one tape side, which may occur with classical music, etc.
3. If the deck is set for one-side recording (), the processing at the tape end is applied only on side A.
CCRS
REC / ARM
The selected disc number is dis-
played when the DP-MH5 is used.
During recording: X-H5
Blinks Lights
Track No.
Program No.
Blinks
Notes
Notes
Character information indicators cannot be displayed while
the spectrum analyzer display is used. Switch to the dual
display or character display mode to see the information.
Note
Note