Filter
Top Products
4 English
P.CON SPEAKER OUTPUT
REMOTE
FUSE
[
30A
x
3
]
GNDBATT.
LINE IN LINE OUT
L
R
SPEAKER OUTPUT SPEAKER OUTPUT
CAUTION
• If sound is not output normally, immediately
turn power off and check connections.
• Be sure to turn the power off before changing
the setting of any switch.
• If the fuse blows, check wires for shorts, then
replace the fuse with one of the same rating.
• Check that no unconnected wires or connectors
are touching the car body. Do not remove
caps from unconnected wires or connectors to
prevent short circuits.
• Connect the speaker wires to appropriate
speaker connectors separately. Sharing the
negative wire of the speaker or grounding
speaker wires to the metal body of the car can
cause this unit to fail.
• After installation, check that the brake lamps,
winkers, and wipers work properly.
* Commercially available parts
WARNING
To prevent fire caused by a short in the wiring,
connect a fusible link or breaker nearby the
battery’s positive terminal.
Connection
Ground wire*
Power control wire*
Subwoofer (L + R)
(≥2Ω)
Battery wire*
Protective Fuse*
RCA cable*
Left input
Right input
Battery
Hexagon Wrench
(Small)
Hexagon Wrench
(Small)
Hexagon
Wrench
(Large)
WARNING
Remove the ignition key and
disconnect the negative · terminal of
the battery to prevent short circuits.
Use the attached
Hexagon Wrench.
Use the
attached
Hexagon
Wrench.
CENTER UNIT
(CD receiver, etc.)
About the Lead Terminals
1. Wire Thicknesses
You can use wires with the following thicknesses:
Battery wire and ground wire AWG 4 – AWG 6
Speaker wire AWG 8 – AWG 12
2. Strip the wire
Make a cut in the wire sheath (insulator made from vinyl, etc.) at the
position 10-13 mm away from the end of the wire, and then remove the
unnecessary portion of the sheath by twisting it.
3. Install the wire
Loosen the screw using the supplied hexagon wrench. Insert the
conductor of the wire in the terminal hole, and then tighten the screw.
When two subwoofers are
connected. (≥4Ω)
(2Ω + 2Ω)(4Ω + 4Ω)
Dual voice coil subwoofer
10 - 13 mm
(3/8" - 1/2")
Hexagon Wrench
(Small)
Hexagon
Wrench
(Large)
Terminal cover
X1200M_K_1English.indd 4 08.10.21 1:32:22 PM