Filter
Top Products
35
EN
In case of difficulty
Remote control unit
Cause
• No setup codes registered at the respective
input(s).
• The remote control is set to a different
operation mode.
• Batteries are exhausted.
• The remote control unit is too far away from
the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
• The audio cords and system control cords are
not connected properly.
•No software is loaded in the source
component.
• An attempt is made to play a tape which is
being recorded in the cassette deck.
• The remote control has not been set to the
operation mode for the component you wish
to control.
Remedy
• Register a setup code at the respective
input(s). º
• Press the any of the REMOTE MODE or INPUT
SELECTOR keys to select the appropriate
operation mode.
• Replace with new batteries.
• Operate the remote control unit within the
controllable range.
• Connect properly referring to “Setting up the
system”.
• Place software in the source component you
want to play.
• Wait until recording has completed.
•Press any of the remote mode keys or
SOURCE
key to activate the operation mode
for the component you want to control before
operation. •
Symptom
Certain inputs cannot be selected using the
remote control.
Remote control operation is not possible.
*5228/30-36/EN 14/06/2002, 12:05 PM35