Kenwood VR-606 VR-616 Stereo Receiver User Manual


 
17
EN
Listening to a source component
1
Use the INPUT SELECTOR knob or keys to select the source
you want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob.
1 “AUX”
2 “TUNER”
3 “CD/DVD”
4 “TAPE” or “MD”
5 “VIDEO 1”
6 “VIDEO 2”
7 “DVD/6CH”
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOLUME +/- keys to
adjust the volume.
Normal playback
Some preparatory steps are needed before starting playback.
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing POWER ON/
STANDBY
key.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO 2
or DVD/6CH jacks, make sure that the input mode setting is correct for
the type of audio signal to be used. 7
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “TAPE”. To change the
source to “MD”, follow the steps below:
1 Use the INPUT SELECTOR knob to select “TAPE”.
2 Hold down the AUTO key for more than 2 seconds.
•The source indication changes to “MD”.
•To return to the original indication, repeat procedure 2.
Setting the speaker status
Press the SPEAKERS ON/OFF key to switch the speakers ON or
OFF.
Preparing for playback
The speaker indicator lights up.
INPUT SELECTOR
POWER
ON/STANDBY
SPEAKERS
ON/OFF
AUTO
INPUT MODE
INPUT SELECTOR
VOLUME CONTROL
VOLUME +
/
INPUT
SELECTOR
*5228/15-18/EN 14/06/2002, 11:58 AM17