Kenwood KRF-X9050D Stereo Receiver User Manual


 
51
Additional Information
Notes
1. KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
2. The full performance may not be exhibited in an extremely cold location (under a water-freezing temperature).
AUDIO section
Rated power output during STEREO operation
110 watts per channel minimum RMS, both channels driven, at
8 from 20 Hz to 20 kHz with no more than 0.7% total harmonic
distortion. (FTC)
Effective power output during SURROUND operation
FRONT (1kHz, 10% T.H.D. at 8 one channel driven)
.............................................................................. 150 W + 150 W
CENTER (1kHz, 10% T.H.D. at 8 one channel driven)
............................................................................................. 150 W
SURROUND (1kHz, 10% T.H.D. at 8 one channel driven)
.............................................................................. 150 W + 150 W
Total harmonic distortion ...........................0.05% (1 kHz, 55W, 8 )
Frequency response
CD ............................................. 10 Hz ~ 60 kHz, +0 dB, –3.0 dB
Signal to noise ratio (IHF’66)
PHONO (MM)........................................................................ 75 dB
CD ......................................................................................... 92 dB
Input sensitivity / impedance
PHONO (MM)............................................................ 4 mV / 27 k
CD ......................................................................... 300 mV / 47 k
MONITOR IN ........................................................300 mV / 47 k
DVD/6CH INPUT .................................................. 300 mV / 47 k
Output level / impedance
TAPE REC .............................................................. 300 mV / 1 k
MONITOR OUT ...................................................... 300 mV / 1 k
PRE OUT (FRONT, CENTER, SURROUND) ............. 1 V / 500
PRE OUT (SUBWOOFER)....................................... 1.8 V / 500
Tone control
BASS ................................................................ ±10 dB (at 70 Hz)
TREBLE .......................................................... ±10 dB (at 10 kHz)
DIGITAL AUDIO section
Sampling frequency ...................... 32 kHz, 44.1 kHz, 48 kHz, 96kHz
Input level / impedance / wave length
Optical .......................... (–15 dBm ~ – 21 dBm), 660 nm ±30nm
Coaxial ................................................................. 0.5 Vp-p / 75
VIDEO section
VIDEO inputs / outputs
VIDEO (composite)............................................ 1 Vp-p / 75
S VIDEO (luminance signal) ................................ 1 Vp-p / 75
(chrominance signal)..................... 0.286 Vp-p / 75
COMPONENT VIDEO (luminance signal) ..................... 1 Vp-p / 75
(C
B
/C
R
-signal)................ +/– 0.324 Vp-p / 75
FM tuner section
Tuning frequency range ................................... 87.5 MHz ~ 108 MHz
Usable sensitivity (MONO)
................ 1.6 µV (75 )/ 15.2 dBf (75 kHz DEV., SINAD 30 dB)
50dB quieting sensitivity
STEREO ................................................... 28 µV (75 )/ 40.2 dBf
Total harmonic distortion (1 kHz)
MONO ............................................................0.5% (65 dBf input)
STEREO ........................................................0.7% (65 dBf input)
Signal to noise ratio (1 kHz, 75 kHz DEV.)
MONO .......................................................... 75 dB (65 dBf input)
STEREO ...................................................... 68 dB (65 dBf input)
Stereo separation (1 kHz) ..........................................................40 dB
Selectivity (±400 kHz).................................................................50 dB
Frequency response ................. (30 Hz ~ 15kHz), +0.5 dB, –3.0 dB
AM tuner section
Tuning frequency range
9 kHz step ................................................... 531 kHz ~ 1,602 kHz
10 kHz step ................................................. 530 kHz ~ 1,610 kHz
Usable sensitivity (30% mod., S/N 20 dB) ......... 16 µV / (600 µV/m)
Signal to noise ratio (30% mod. 1 mV input)...........................50 dB
GENERAL
Power consumption .................................................................. 270 W
AC outlet
SWITCHED ...................................................... (total 90 W max.)
Dimensions ...................................................................... W : 440 mm
H : 144 mm
D : 399 mm
Weight (Net) ........................................................................... 10.25 kg
Specifications
Caution : Read this page carefully to ensure safe
operation.