Kenwood KRF-X9060D Stereo Receiver User Manual


 
51
EN
Notes
1. KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
2. The full performance may not be exhibited in an extremely cold location (under a water-freezing temperature).
Specifications
For the U.K. only
AUDIO section (KRF-X9060D)
Rated power output during STEREO operation
DIN/IEC (20 Hz ~ 20 kHz, 0.09% T.H.D. at 6 )
............................................................................... 100 W + 100 W
Effective power output during SURROUND operation
FRONT (20 Hz ~ 20 kHz, 0.09% T.H.D. at 6 one channel driven)
............................................................................... 100 W + 100 W
CENTER (
20 Hz ~ 20 kHz, 0.09%
T.H.D. at 6
one channel
driven) .....................................................................................
100 W
SURROUND (
20 Hz ~ 20 kHz, 0.7%
T.H.D. at 6
one channel
driven)............................................................................
100 W + 100 W
SURROUND BACK/SUBWOOFER (20 Hz ~ 20 kHz, 0.09%
T.H.D.
at 6 one channel driven) ..................................... 100 W
Total harmonic distortion ........................0.009% (1 kHz, 50 W, 6 )
Frequency response
Line (CD/DVD, TAPE, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH)
.................................................10 Hz ~ 100 kHz, +0 dB ~ 3.0 dB
PHONO RIAA response ..............40 Hz ~ 20 kHz, +1.5 dB ~ 3.0 dB
Maximum input level
PHONO (MM).....................................45 mV, 1% T.H.D. at 1 kHz
Signal to noise ratio (IHF66)
PHONO (MM)........................................................................ 75 dB
Line (CD/DVD, TAPE, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH)
............................................................................................... 95 dB
Loudness control
VOLUME at 30 dB level ...................................... +6 dB (100 Hz)
Input sensitivity / impedance
PHONO (MM)........................................................ 4.0 mV / 47 k
Line (CD/DVD, TAPE, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH)
.............................................................................. 320 mV / 47 k
Output level / impedance
TAPE REC ............................................................... 320 mV / 1 k
PRE OUT (FRONT,CENTER,SURROUND) .................1 V / 500
PRE OUT (SURROUND BACK) ...................................1 V / 500
PRE OUT (SUBWOOFER) .......................................... 1 V / 500
Tone control
BASS................................................................ ±10 dB (at 100 Hz)
TREBLE ............................................................ ±10 dB (at 10 kHz)
DIGITAL AUDIO section
Sampling frequency ...................... 32 kHz, 44.1 kHz, 48 kHz, 96 kHz
Input level / impedance / wave length
Optical ........................... (15 dBm ~ 24 dBm), 660 nm ±30 nm
Coaxial...................................................................0.5 Vp-p / 75
Output level / impedance / wave length
Optical ........................... (21 dBm ~ 15 dBm), 660 nm ±30 nm
VIDEO section
VIDEO inputs / outputs
VIDEO (composite) ................................................. 1 Vp-p / 75
S VIDEO inputs /outputs
S VIDEO (luminance signal)................................... 1 Vp-p / 75
S VIDEO (chrominance signal) .......................0.286 Vp-p / 75
COMPONENT VIDEO inputs /outputs
COMPONENT VIDEO (luminance signal) ............. 1 Vp-p / 75
COMPONENT VIDEO (CB/CR-signal).............±0.32 Vp-p / 75
FM tuner section
Tuning frequency range.....................................87.5 MHz ~ 108 MHz
Usable sensitivity
MONO............ 1.3 µV (75 )/ 13.2 dBf (40 kHz dev, S/N 26 dB)
STEREO .... 45 µV (75 )/ 42.1 dBf (40 + 6 kHz dev, S/N 46 dB)
Total harmonic distortion
MONO (1 kHz, 40 kHz dev) .......................0.2% (65.2 dBf input)
STEREO (1 kHz, 40 + 6 kHz dev)...............0.8% (65.2 dBf input)
Signal to noise ratio (DIN weighted at 1 kHz)
MONO........................................................ 65 dB (65.2 dBf input)
STEREO ..................................................... 60 dB (65.2 dBf input)
Stereo separation (1 kHz)........................................................... 36 dB
Selectivity (±300 kHz) ................................................................. 64 dB
Frequency response (30 Hz ~ 15 kHz) .................... +0.5 dB, 3.0 dB
MW tuner section
Tuning frequency range..................................... 531 kHz ~ 1,602 kHz
Usable sensitivity (30% mod, S/N 20 dB) .........16 µV / (600 µV/m)
Signal to noise ratio (400 Hz, 30% mod)
.......................................................... 50 dB (60 dBµ VEMF input)
GENERAL
Power consumption ................................................................. 330 W
AC outlet
SWITCHED ...................................................... (total 90 W max.)
Dimensions..................................................... W : 440 mm (17-5/16")
H : 159 mm (6-1/4")
D : 392 mm (15-7/16")
Weight (Net)................................................................ 9.8 kg (21.6 lb)
•VR6070/42-52/EN 3/29/02, 2:48 PM51