Kenwood KRF-V6070D Stereo Receiver User Manual


 
38
EN
In case of difficulty
Remote control unit
Cause
No setup codes registered at the respective
input(s).
•The remote control is set to a different
operation mode.
Batteries are exhausted.
The remote control unit is too far away from
the main system, controlling angle is too
large, or there is an obstacle between the
receiver and the remote.
• The audio cords and system control cords are
not connected properly.
•No tape or CD is placed in the source
component.
An attempt is made to play a tape which is
being recorded in the cassette deck.
The remote control has not been set to the
operation mode for the component you wish
to control.
Remedy
Register a setup code at the respective
input(s).
Press the any of the Input Selector keys to
select the appropriate operation mode.
Replace with new batteries.
Operate the remote control unit within the
controllable range.
• Connect properly referring to “Setting up the
system”.
• Place the tape or CD in the source component
which you want to play.
Wait for recording to complete.
Press any of the source keys or SRC Power
key to activate the operation mode for the
component you want to control before
operation. ª
Symptom
Certain inputs cannot be selected using the
remote control.
Remote control operation is not possible.
*5330/37-40/EN 1/21/03, 9:58 PM38