Kenwood KRF-V6070D Stereo Receiver User Manual


 
17
EN
Preparing for surround sound
0 Use the MULTI CONTROL knob or Multi %/ keys to select
the appropriate surround speaker setting.
If you have selected “LRG” as the center speaker setting,
1 SURR NML (normal): Average size surround speakers are
connected to the receiver.
2 SURR LRG (large) : Large surround speakers are connected
to the receiver.
3 SURR OFF : Surround speaker setting mode to the
receiver is OFF.
If you have selected other than “LRG” as the center speaker
setting,
1 SURR ON : Surround speaker setting mode to the receiver is
ON.
2 SURR OFF : Surround speaker setting mode to the receiver is
OFF.
• When the setting “SURR OFF” is selected, the procedure skips
to step %.
! Press the SETUP key to accept the setting.
The surround back speaker setting indication “SB” appears.
@ Use the MULTI CONTROL knob or Multi %/ keys to select
the appropriate surround back speaker setting.
If you have selected “LARGE” as the surround speaker setting,
1 SB NORMAL : Average size surround back speaker is
connected to the receiver.
2 SB LARGE : Large surround back speaker is connected to
the receiver.
3 SB OFF : Surround back speaker setting mode to the
receiver is OFF.
If you have selected “NORMAL” as the surround speaker
setting,
1 SB ON : Surround back speaker setting mode to the receiver
is ON.
2 SB OFF : Surround back speaker setting mode to the receiver
is OFF.
# Press the SETUP key to accept the setting.
The surround mix setting indication “SURR MIX” appears.
• SURR MIX is when the SL and SR speakers signals are mixed to
produce sound from the surround back speaker which would
enable the listener to enjoy sound coming from the back.
$ Use the MULTI CONTROL knob or Multi %/ keys to select
the surround mix setting.
1 MIX OFF : Surround mix setting mode is OFF.
2 MIX ON : Surround mix setting mode is ON.
% Press the SETUP key again to accept the setting.
The subwoofer re-mix setting indication “SW RE-MIX” scrolls
across the display.
If subwoofer is turned OFF, subwoofer re-mix setting is not
visible.
^ Use the MULTI CONTROL knob or Multi %/ keys to
select the appropriate subwoofer re-mix setting.
1 RMX ON : Subwoofer re-mix set mode to the receiver is ON.
2 RMX OFF : Subwoofer re-mix set mode to the receiver is OFF.
& Press the SETUP key to accept the setting.
•The receiver enters the speaker volume level adjustment mode.
•In step 5 and 6, indications appear only for the selected channels
of the speakers that require adjusting.
5
Adjust the speaker volume level.
From your usual listening position, adjust the volume levels. The
volume levels from each speaker should be the same.
1 Press the SETUP key to begin TEST TONE.
The selection of AUTO/MANUAL TEST TONE is done by the
MULTI CONTROL knob or Multi %/ keys.
1 AUTO
2 MANUAL
2 Press the SETUP key again to select either AUTO or MANUAL.
Use the MULTI CONTROL knob or Multi %/ keys to adjust
the volume level of the test tone output from the speaker
channel to be adjusted.
For AUTO selection, the test tone is heard from the speakers
in the following sequence for 2 seconds each:
If you change the volume level settings for the speakers while
listening to music, the settings referred to on this page are also
changed. §
If any of the speaker is set as OFF during SP SETUP, the TEST
TONE adjustment for the speaker will be skipped.
3 Press the SETUP key.
The test tone is turned off. The receiver enters the mode for
inputting the distance to the speakers.
4 For MANUAL selection, press the SETUP key each time to
select the speaker channel.
6
Input the distance to the speakers.
1 Select the DISTANCE from the set up displays and press the
SETUP key again.
2 Measure the distance from the listening position to each of
the speakers.
Jot down the distance to each of the speakers.
Distance to Front left speaker (L) : ____ feet (meters)
Distance to Center speaker (C) : ____ feet (meters)
Distance to Front right speaker (R) : ____ feet (meters)
Distance to Surround right (SR) : ____ feet (meters)
Distance to Surround back (SB) : ____ feet (meters)
Distance to Surround left (SL) : ____ feet (meters)
Distance to Subwoofer (SW) : ____ feet (meters)
3 Use the MULTI CONTROL knob or Multi %/ keys to select the
distance to the front speakers.
Indication in feet Indication in meters
The allowable setting range is 1 to 30 feet (0.3m to 9.0m),
adjustable in 1 foot (0.3m) increments.
4 Press the SETUP key to accept the settings.
Continued to next page
*5330/16-22/EN 1/23/03, 2:01 PM17