Filter
Top Products
19
EN
Listening to a source component
1
Use the INPUT SELECTOR knob or keys to select the source
you want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob.
VR-605/615/KRF-V5060D/V4060D/V5560D
1 “AUX”
2 “TUNER”
3 “CD/DVD”
4 “TAPE” or “MD”
5 “VIDEO1”
6 “VIDEO2”
7 “DVD” or “DVD/6CH” (for VR-615/KRF-V5060D only)
KRF-V5060D (for the U.K. and Europe only)
1 “PHONO”
2 “TUNER”
3 “CD/DVD”
4 “TAPE” or “MD”
5 “VIDEO1”
6 “VIDEO2”
7 “DVD/6CH”
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOLUME keys to adjust
the volume.
Normal playback
Some preparatory steps are needed before starting playback.
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing POWER ON/
STANDBY
(for VR-605/615) or POWER ON/OFF and ON/
STANDBY
(for KRF-V5060D/V4060D/V5560D) key.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO2,
DVD or DVD/6CH (VR-615/KRF-V5060D only) jacks, make sure that
the input mode setting is correct for the type of audio signal to be used.
8
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “TAPE”. To change the
source to “MD”, follow the steps below:
1 Use the INPUT SELECTOR knob to select “TAPE”.
2 Hold down the AUTO key for more than 2 seconds.
• The source indication changes to “MD”.
• To return to the original indication, repeat procedure 2.
Setting the speaker status
Press the SPEAKER key to switch the speaker ON or OFF.
Preparing for playback
The speaker indicator lights up.
AUTO
INPUT MODE
INPUT SELECTOR
(KRF-V5060D/
V4060D/
V5560D)
POWER
ON/OFF
SPEAKER
ON/OFF
ON/STANDBY
(KRF-V5060D/ V4060D
/
V5560D)
(VR-605/615)
POWER
ON/STANDBY
INPUT SELECTOR
VOLUME CONTROL
INPUT
SELECTOR
VOLUME
*5197/17-21/EN 26/03/2002, 2:52 PM19